15534 Autoloader ALE: %s %d timed out while moving Trendsetter_VLF Platesetter_VLF Check for a low value of the NVS parameter "move_timeout" by typing "set altim move" in the diagnostic monitor. This value is the maximum time allowed by the firmware for moving a stepper axis. Verify the mechanics for anything that could prevent the axis from moving at a normal pace. This is not an operator serviceable error. Press resume or reset the machine to continue production. Call CreoScitex response center. An axis is taking too much time to move to the desired position. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:10 2008 PST http://techplanet.creo.com/output/computer_to_plate/vlf_platesetter/content/troubleshooting/15534.htmOther: Troubleshooting information